Color steel activity room is now very common, although light, but the structure of the whole good, earthquake resistance is good, the house can be disassembled and disassembled many times, the utilization rate is high. It should be noted that there are certain requirements for the assembly site and environment in the color steel activity room.

1.地基的硬度：在浇注底子前，要事前测量佳地基的硬度，如有地形特殊或地基硬度相次太大，务必作特殊处理，以确保板房能顺利装配和保障装配后的质量，如何特殊处理，与技能部沟通。

1. Hardness of foundation: before pouring the foundation, measure the hardness of the foundation before pouring. If there is special terrain or the hardness of foundation is too large, special treatment must be made to ensure the smooth assembly of the board house and ensure the quality after assembly. How to deal with special treatment, communicate with the skill department.

2.底子的程度：在底子浇注时，必定要测量佳程度，底子浇注完后，程度误次操纵在10MM以内。

2. The degree of the base: when pouring the base, it is necessary to measure the good degree. After the bottom pouring, the error degree is controlled within 10 mm.

3.混泥土标号：大局部尺度板房底子为C20。平常情况下内无钢筋，如有地形、地基特殊情况或板房有特殊要求，应以技能部出图为准。

3. Concrete label: C20 for the floor of large local scale slab house. Under normal circumstances, there is no reinforcement in it. If there are special conditions of terrain, foundation or slab house, the drawing of skill department shall prevail.

4.底子浇注时间：彩钢活动房的底子浇注应与惯例的混泥土浇注工艺一样，不可减少工艺秩序。在底子浇注完成到板房装配之间应留有充沛时间，以确保混泥土到达必定的硬度。

The pouring process should not be the same as the pouring process of steel base. Sufficient time should be left between the bottom pouring and the panel room assembly to ensure that the concrete reaches a certain hardness.

5.要求：为保障装配工期，装配质量和装配后整洁美观，在制造底子的同时，把室内地面也一并浇注完成，程度高度与底子一样，在板房装配完成后，在室内铺地板既方便，又整洁，也不会影响板房的质量和外观。室内地板的高度应比底子程度高度高出50MM，以确保雨水不会流入室内和地圈梁的坚实水平。

5. Requirements: in order to ensure the assembly time limit, assembly quality and neatness and beauty after assembly, the indoor floor shall be poured at the same time while the substrate is manufactured, and the degree is the same as that of the substrate. After the completion of the panel room assembly, it is convenient and tidy to lay the floor indoors, and the quality and appearance of the board room will not be affected. The height of the indoor floor should be 50 mm higher than the height of the bottom level to ensure that rainwater will not flow into the room and the solid level of the ground ring beam.

只有把装配地点和环境的要求达到了，装出来的彩钢活动房才能坚固耐用，更好的保证使用。

Only when the requirements of assembly site and environment are met, the color steel movable room can be durable and safe.