Color steel movable houses are now very common. Although they are light in weight, they have good overall structure and good earthquake resistance. The house can be disassembled and disassembled in many ways, and the utilization rate is high. It should be noted that there are certain requirements for the assembly location and environment in the color steel movable room.

1.地基的硬度：在浇注底子前，要事前测量佳地基的硬度，如有地形特殊或地基硬度相次太大，务必作特殊处理，以确保板房能顺利装配和保障装配后的质量，如何特殊处理，与技能部沟通。

1. Foundation hardness: before pouring the foundation, measure the hardness of the good foundation before important matters. If there is special terrain or the foundation hardness is too large, special treatment must be made to ensure the smooth assembly of the plank house and ensure the quality after assembly. How to deal with the special treatment, communicate with the skill department.

2.底子的程度：在底子浇注时，必定要测量佳程度，底子浇注完后，程度误次操纵在10MM以内。

2. Base degree: during base pouring, the degree must be measured. After base pouring, the degree is manipulated within 10mm by mistake.

3.混泥土标号：大局部尺度板房底子为C20。平常情况下内无钢筋，如有地形、地基特殊情况或板房有特殊要求，应以技能部出图为准。

3. Concrete grade: C20 at the bottom of large-scale slab house. Under normal circumstances, there is no reinforcement in the. In case of special terrain, foundation or slab house, the drawing of the skill department shall prevail.

4.底子浇注时间：彩钢活动房的底子浇注应与惯例的混泥土浇注工艺一样，不可减少工艺秩序。在底子浇注完成到板房装配之间应留有充沛时间，以确保混泥土到达必定的硬度。

4. Bottom pouring time: the bottom pouring of color steel movable house shall be the same as the conventional concrete pouring process, and the process order cannot be reduced. Sufficient time shall be reserved between the completion of base pouring and the assembly of slab house to ensure that the concrete reaches a certain hardness.

5.要求：为保障装配工期，装配质量和装配后整洁美观，在制造底子的同时，把室内地面也一并浇注完成，程度高度与底子一样，在板房装配完成后，在室内铺地板既方便，又整洁，也不会影响板房的质量和外观。室内地板的高度应比底子程度高度高出50MM，以确保雨水不会流入室内和地圈梁的坚实水平。

5. Requirements: in order to ensure the assembly period, assembly quality and tidiness and beauty after assembly, the indoor floor shall be poured at the same time as the bottom. The degree and height are the same as the bottom. After the assembly of the board room, it is convenient and tidy to lay the floor indoors, and will not affect the quality and appearance of the board room. The height of the indoor floor shall be 50mm higher than the base level to ensure that rainwater will not flow into the room and the solid level of the ground ring beam.

只有把装配地点和环境的要求达到了，装出来的彩钢活动房才能坚固耐用，更好的保证使用。

Only when the requirements of assembly location and environment are met, the installed color steel movable room can be firm and durable and better ensure the use safety.