1、工人应接受防护教育，每天班前主要点关注施工操作要点，加强质量意识教育。每道工序施工前，应向工人进行详细的技能交底。
1. Workers should first receive protection education, pay attention to the key points of construction operation before work every day, and strengthen quality awareness education. Before the construction of each process, detailed skill disclosure shall be made to the workers.
2、工程所需的所有材料和设备需要有合格证或材质证明，各种证明要挂牌登记，并与实物核对。没有这份文件，检查或建设可能会被拒绝。如有疑问，应进行检查判断，经检查合格后方可使用。
2. All materials and equipment required for the project shall be provided with certificates or material certificates. Various certificates shall be listed and registered and checked with the physical objects. Without this document, inspection or construction may be rejected. In case of doubt, it shall be checked and judged, and can be used only after passing the inspection.
3、彩钢板装置应平直，板面不应有施工残留物和污垢。檐口应在一条直线上，不应有未经处理的错钻。
3. The color steel plate device shall be straight, and the plate surface shall be free of construction residues and dirt. The cornice shall be in a straight line, and there shall be no untreated wrong drilling.
4、运输、堆积和吊装禁止彩板变形和油漆脱落。
4. During transportation, stacking and hoisting, the color plate shall not be deformed and the paint shall not fall off.
5、山墙泛洪层顶部高250mm，沿屋面坡度高10mm、15mm。其次，用M6膨胀螺栓固定防水板与凹槽的连接处，并用密封胶密封外露的膨胀螺栓；与车顶板的接头用自攻螺钉固定在车顶板支架上，防水板与车顶板的接头用长挡水带防水。
5. The top of the gable flood layer is 250mm high, and the height along the roof slope is 10mm and 15mm. Secondly, fix the joint between waterproof board and groove with M6 expansion bolt, and seal the exposed expansion bolt with sealant; The joint with the roof panel is fixed on the roof panel support with self tapping screws, and the joint between the waterproof board and the roof panel is waterproof with a long water retaining belt.
6、形成彩钢板后，涂层和镀层上不应有可见的裂纹、剥落和划痕。
6. After the color steel plate is formed, there shall be no visible cracks, peeling and scratches on the coating and coating.
7、彩钢板、泛水板和角板应固定牢固，防腐涂料和密封材料应铺设完好。
7. Color steel plate, flashing plate and corner plate shall be fixed firmly, and anti-corrosion coating and sealing materials shall be laid in good condition.
8、彩钢板形成后，外观应干净，不应有明显的凹凸和皱纹。
8. After the color steel plate is formed, the appearance shall be clean without obvious concave convex and wrinkles.
9、项目经理部及其他作业力量应严格按照批准的技术文件施工，不得随意变更。现场技术人员和质量检查员工有权对性能状况进行检查，并及时纠正违反既定方法的施工方法。
9. The project management department and other operation forces shall construct in strict accordance with the approved technical documents and shall not change at will. On site technicians and quality inspection staff have the right to inspect the performance status and correct the construction methods that violate the established methods in time.
10、如发现彩钢板原施工工艺有缺陷，现场技术负责人提出修改意见，经原批准部分批准后，以技能联系单形式告知变更。
10. If the original construction process of color steel plate is found to be defective, the on-site technical director shall put forward modification opinions, and inform the change in the form of skill contact sheet after being approved by the original approval part.
11、施工人员可对批准的技能和方法提出合理建议，经原批准部分批准后，用联系单告知变更。
11. The construction personnel can put forward reasonable suggestions on the approved skills and methods, and inform the change with the contact list after being approved by the original approval part.
The above is the knowledge brought to you today. Jinan color steel plank house has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.lxcaigang.com
