彩钢板的应用还需要满足各种条件。只有在施工过程中注意这些细节，才能更好地发挥产品的作用。更多
济南彩钢板的相关内容将由我们的工作人员为您解释：
The application of color steel plate also needs to meet various conditions. Only by paying attention to these details in the construction process can we better play the role of the product. More relevant contents of Jinan color steel plate will be explained to you by our staff:
1.尽量避免在阳光直射和灰尘飞扬的情况下施工彩钢板。
1. Try to avoid the construction of color steel plate under direct sunlight and flying dust.
2.严禁在潮湿表面涂漆；露点温度取决于环境相对湿度和空气温度的组合。
2. It is forbidden to paint on wet surfaces; The dew point temperature depends on the combination of ambient relative humidity and air temperature.
3.工作环境应清洁、干燥、通风。环境温度5℃以上，相对湿度85%以下，方可施工。如果超过任何限制，应立即采取措施，否则不得施工。
3. The working environment should be clean, dry and ventilated. The construction can only be started when the ambient temperature is above 5 ℃ and the relative humidity is below 85%. If any limit is exceeded, immediate measures shall be taken, otherwise construction shall not be carried out.
4.避免在强风中工作；在炎热天气下工作时，应避免冷却气流的影响。如果在这种环境下工作，只能使用刷涂，并做好防尘工作。
4. Avoid working in strong wind; When working in hot weather, avoid the influence of cooling airflow. If you work in this environment, you can only use brush painting and do a good job of dust prevention.
5.彩钢板室外施工时，遇雨、雾、露或表面可能潮湿时，应停止施工。
5. During the outdoor construction of color steel plate, the construction shall be stopped in case of rain, fog, dew or the surface may be wet.
此外在安装彩钢板时应注意：
In addition, pay attention to the following when installing color steel plate:
1.安装彩钢板固定件，并用自攻螺钉将固定件固定在檩条上，自攻螺钉安装在每根檩条上。
1. Install the color steel plate fastener, and fix the fastener on the purlin with self-tapping screws, and install the self-tapping screws on each purlin.
2.在固定件上放置一块钢板，与各固定件的肋底槽和内肋压紧，并完全啮合。
2. Place a steel plate on the fastener, press it tightly with the bottom groove of the central rib and the inner rib of each fastener, and fully mesh.
3.钢管×3M脚手架搭设2根4m长管道，每根脚手架设4个轮子，便于推进。
3. Steel pipe × Two 4m long pipes shall be set up on 3M scaffold, and four wheels shall be set up on each scaffold to facilitate propulsion.
4.先安装车顶内层板。根据技术要求，每个波峰用30mm长的专用自攻螺钉固定，螺帽颜色与彩钢板颜色一致。
4. Install the inner roof panel first. According to the technical requirements, each wave crest is fixed with a 30mm long special tapping screw, and the color of the nut is consistent with that of the color steel plate.
5.用彩钢板铺设保温棉，保温棉接缝用专用胶带密封。
5. Pave insulation cotton with color steel plate, and seal the joint of insulation cotton with special tape.
The color steel products produced by our company are light in weight and convenient in transportation. They can be used in suburban and urban areas. The utility model has beautiful appearance, bright color and cost saving. Buy when you need it http://www.lxcaigang.com Come on!
